Ultra GammaView 2555 User Manual download pdf (Page 17)

- 17 -

The Firmware Upgrade Utility

To upgrade the GammaView’s firmware, do the following:

1. From a computer that is not part of your KVM installation,

download the latest Firmware Upgrade package for the KVM

from our Internet support site (www.ultraproducts.com).

2. Disconnect the GammaView from your KVM installation.

Press and hold the Remote Port Selector’s pushbutton. While

you are still holding the pushbutton, connect the KVM cable’s

purple USB connector to a USB port on the computer you

have downloaded the Firmware Upgrade package to.

3. The GammaView now enters Firmware Upgrade Mode. The

two Ports LEDs flash together to indicate that the unit is in

Firmware Upgrade Mode.

Note: While the GammaView is in Firmware Upgrade Mode,

normal keyboard and mouse functions are suspended.

You must complete the firmware upgrade or exit

Firmware Upgrade Mode to regain normal control of the

console.

4. Run the Firmware Upgrade Package file. The Firmware

Upgrade Utility Welcome screen appears.

5. Read the License Agreement and enable to I Agree button.

6. Click Next to continue. The Firmware Upgrade Utility main

screen appears. All the devices capable of being upgraded by

the package are listed in the Devices List panel.

7. Select your device. Its description appears in the Device

Description panel. Click Next to perform the upgrade.

As the upgrade proceeds, status messages appear in the

Status Messages panel, and the progress towards completion

is shown in the Progress bar.

8. After the upgrade has completed, a screen appears to inform

you that procedure was successful. Click Finish to close the

Firmware Upgrade Utility.

9. Set up your KVM installation again. See Installation, page 11.

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

Ultra GammaView 2555 User Manual Page 17